Firmware updates

Information about the firmware update for the RM-LP100E

Version: V0200


Points of improvement in reference to the previous version

(September, 2017)

New Supported cameras : GY-HM890/HM850/HM660/HM200 in addition to KY-PZ100



This software should only be uploaded to the unit for which it is intended. If this software is uploaded to a unit other than the product it is designed for, it will render the unit inoperative.
If the software upload fails, and subsequent upload attempts prove unsuccessful, the unit may need to be returned to JVC for service.  


Software License Agreement
By downloading, installing, or using this software, you agree to be bound by the terms and conditions of the following license agreement. Please read this agreement carefully.

JVC grants you a limited, non-exclusive license to use the upgrade software ("Software") in binary executable form in the normal operation of the applicable JVC products. Title, ownership rights, and intellectual property rights in and to the Software remain in JVC. This license is personal to you and you may make copies of the software only for your personal use. You agree that this license agreement does not need to be signed for it to take effect.

The software is provided on an "as is" basis without warranty of any kind -- either expressed or implied -- including, without limitation, any implied warranties of merchantability or fitness for a particular purpose. JVC does not warrant the performance of the software or that the software will meet your requirements or operate error free.



After the memory card is removed, the camera will re-start automaticaooy.


Please format the USB memory by FAT32.
(It does not recognize if you format other than FAT32.)


Please input the update file(*.bin) to the root folder of USB memory


Please connect the USB memory to SERVICE terminal of RM-LP100.


Please turn on the POWER switch while holding down "USER1" and "USER2" button
(■ 2 button on the upper left).


Please press and hold the button until the "USB Firmware Update Mode" screen.


Please check the displayed firmware version is same as the version that was
input the USB memory


Please push "Update" button



Please push "OK".
--> Firmware update Start.



Firmware writing was completed.
Please turn off and reboot.


Please make shure you read the "Firmware Update Procedure" - RM-LP100.pdf